With a mouthpiece
- Shake the puffer and take the cap off.
- Fit the puffer into the opening at the back of the spacer.
- Breathe out gently, away from the spacer.
- Put the mouthpiece in your mouth and close your lips firmly around it.
- Press the puffer once, then breathe in and out normally four or five times through the spacer.
- For a second dose, wait about 30 seconds, shake the puffer again, and repeat from step 3.
That is the whole method. The thing people find hardest to believe is that normal breathing is enough. It is. The chamber is doing the work that your timing used to have to do.
With a mask
The same, with three differences.
- Shake the puffer and fit it to the spacer, with the mask attached.
- Place the mask over the nose and mouth together, pressing gently but firmly so the whole rim touches the face.
- Press the puffer once, and keep the mask in place for four or five normal breaths.
- For a second dose, wait about 30 seconds, shake again, repeat.
With a mask the child does not need to breathe through their mouth, which is the entire reason masks exist for this age group.
Watch the valve. On a clear spacer you can see it move with each breath. That is your confirmation the child is actually drawing from the chamber.
The four mistakes that cost you the dose
Firing two or three puffs into the chamber at once. Each dose should be fired separately. Multiple puffs make the particles clump together and settle on the chamber wall instead of staying suspended.
Holding the mask loosely. Any gap at the edge lets room air in and the dose out. A mask that is too large is the most common version of this problem.
Waiting too long after firing. The medication does not hang in the chamber indefinitely. Start breathing straight away.
Breathing in too fast. Fast, sharp breaths throw more of the dose against the back of the throat. Slow and normal is what you want, which is why some masks whistle once the breath reaches the right speed.
How long should it take?
Under a minute for a single dose. If someone is telling you to hold your breath for ten seconds, count to thirty, or perform some other ritual, check the instructions that came with your device. Four or five normal breaths is the method for most spacers.
Before the first use
Wash a new spacer before you use it. New plastic carries a static charge that will pull the first few doses onto the chamber wall. Washing it reduces that charge.
Wash it in warm soapy water, do not rinse, and let it air dry standing up. The full method and the reasons behind it are on the cleaning page, and it is worth two minutes of your time because it changes how much medication you get for the life of the device.
If you are not sure you are doing it right
Ask your pharmacist to watch you. Technique drifts, and most people have never been checked after the day they were diagnosed.
Frequently asked questions
How many breaths should I take? Four or five normal breaths through the spacer for each dose, unless your device's instructions say otherwise.
Should I hold my breath? Normal breathing through the chamber is the usual method with a spacer. Follow the instructions supplied with your device.
Can I take both puffs at once to save time? No. Fire one dose, breathe, wait about 30 seconds, then fire the second.
The child cries and pulls away. What do I do? Hold the mask on gently rather than pressing, approach from the side rather than head on, count the breaths out loud, and practise when they are well. More on this in the mask size guide.
This article is general information, not medical advice. Always follow the instructions for use supplied with your device, and your doctor's or pharmacist's advice on your medication.




